#OSCULATOR APP SOFTWARE#
If you would like to control your switcher using a MIDI board or device, consider pairing this software with OSCulator or MidiPipe. SendOSC also enables using AtemOSC with ControllerMate and X-keys. See the actionscript example in this repository for an example of using AppleScript and sendOSC. If you would like to send OSC from AppleScript or Terminal commands, you can download and use the sendosc command. You can find the IP address of a macOS computer by going to System Preferences > Network or by running ifconfig in a terminal window. If you are sending atemOSC messages from another device, you will need to send it to the IP address of the computer running atemOSC on the port that atemOSC is listening on. If you are sending atemOSC messages from a queueing software or translation software on the same computer that atemOSC is running on, make sure to send messages to 127.0.0.1 (localhost) on the port that atemOSC is listening on. If you set an outgoing IP address and port, atemOSC will send status updates and feedback OSC messages to the IP address and port you specified. Under Assets, select atemOSC_.dmgĪfter launching the application, enter the IP address of the switcher and which local port to listen on (default 3333), and then send OSC commands to the IP address of the computer running atemOSC that port.For a version that supports older versions of the Atem SDK, scroll down until you find the release for the version you want.AtemOSC is a network proxy, listening for commands following the OSC protocol and executing those commands on Blackmagic ATEM video switchers.įor best results, run the latest version of atemOSC, make sure your switcher(s) is running the latest version of the ATEM firmware, and make sure that the Mac that atemOSC is running on has the latest version of ATEM Software Control installed (or at least the same version as the switcher firmware, if the switcher does not support the latest version).
0 kommentar(er)
